Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1788

Spf Delay Time The number of seconds to wait before running a routing table calculation after a topology change. Spf Hold Time The minimum number of seconds between routing table calculations. Flood Pacing Interval The average time, in milliseconds, between LS Update packet transmissions on an interface. This is the value configured with the timers pacing flood command. LSA Refresh Group Pacing Time The size of the LSA refresh group window, in seconds. This is the value configured with the timers pacing lsa-group command. Opaque Capability Shows whether router is capable of sending Opaque LSAs. AutoCost Ref BW The configured autocost reference bandwidth. This value is used to determine the OSPF metric on its interfaces. The reference bandwidth is divided by the interface speed to compute the metric. Default Passive Setting When enabled, OSPF interfaces are passive by default. Maximum Paths Shows the maximum number of paths that OSPF can report for a given destination. Default Metric Default metric for redistributed routes. Stub Router Configuration One of Always, Startup, or None. Stub Router Startup Time Configured value in seconds. This row is only listed if OSPF is configured to be a stub router at startup. Summary LSA One of Enabled (met), Disabled, where met is the metric to be Metric Override sent in summary LSAs when in stub router mode. BFD Enabled The BFD status. Default Route Advertise When enabled, OSPF originates a type 5 LSA advertising a default route. Always When this option is configured, OSPF only originates a default route when the router has learned a default route from another source. Metric Shows the metric for the advertised default routes. If the metric is not configured, this field is not configured. Layer 3 Routing Commands 1788