Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1436

show ip bgp neighbors advertised-routes The show ip bgp neighbors advertised-routes command displays the list of routes advertised to a specific neighbor. These are the routes in the adjacent RIB out for the neighbor's outbound update group Syntax show ip bgp [vrf vrf-name] neighbors ip-address advertised-routes • ip-address-The IPv4 address of a neighbor. • vrf vrf-name - Displays the aggregate address information associated with the named VRF. Default Configuration By default, information about the global VRF is shown. Command Mode Privileged Exec mode, Global Configuration mode, and all sub-modes User Guidelines Note that this output differs slightly from the output in show ip bgp. Suppressed routes and non-best routes are not advertised; so these status codes are not relevant here. Advertised routes always have a single next hop, the BGP NEXT HOP advertised to the peer. Local preference is never sent to external peers. If the vrf-name argument is specified, information pertaining to that VRF is displayed. The output indicates whether BGP is configured to originate a default route to this peer (neighbor default-originate). Counters BGP table version Status codes Description Each time phase 2 of the BGP decision process runs to select new BGP routes, this number is incremented. p-The route has been updated in Adj-RIB-Out since the last UPDATE message was sent. Transmission of an UPDATE message is pending. Layer 3 Routing Commands 1436