Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 305

• time-range-name-Use the time-range parameter to impose a time limitation on the MAC ACL rule as defined by the parameter. • assign-queue-Specifies particular hardware queue for handling traffic that matches the rule. • queue-id -0-6, where n is number of user configurable queues available for that hardware platform. The queue ID is the internal queue number (traffic class), not the CoS value. Use the show classofservice command to display the assignment of CoS and DSCP values to internal queue numbers. • mirror-Copies the traffic matching this rule to the specified interface. The port mirroring logic state occurs after the tag processing stage on ingress. Egress mirroring is not supported. • redirect-Forwards traffic matching this rule to the specified Ethernet interface. The redirect logic stage occurs after the tag processing stage on ingress. Egress redirect is not supported. • interface-id-An Ethernet interface identifier, for example gi1/0/12. • rate-limit rate burst-size-Specifies the allowed rate of traffic per the configured rate in Kbps and burst-size in kbytes. Rate limits only apply to permit rules. - Rate- The committed rate in kilobits per second - Burst-size-The committed burst size in Kilobytes. Default Configuration An implicit deny all condition is added by the system after the last MAC or IP/IPv6 access group if no route-map is configured on the interface. Command Mode Mac-Access-List Configuration mode User Guidelines The assign-queue and redirect parameters are only valid for permit commands. An implicit deny all condition is added by the system after the last MAC or IP/IPv6 access group if no route-map is configured on the interface. Layer 2 Switching Commands 305