Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 511

Table 3-7. show ethernet ring g8032 profile command output Field Profile name WTR interval Guard interval Holdoff interval Revertive mode Guard timer Hold-off timer Wait-to-Restore timer Description The name of the profile. When all faults are cleared, the period to wait before restoring the original traffic channel. The period to wait before invoking a protection switch. The period to wait before reporting a defect to protection switching. If enabled, revert to the original traffic channel when all faults are cleared. The guard timer is used to prevent ring nodes from acting upon outdated R-APS messages and prevents the possibility of forming a closed loop. Range: 10 ms to 2000 ms in steps of 10 ms. When a new defect or more severe defect occurs, this event will not be reported immediately to protection switching if the provisioned hold-off timer value is nonzero. Instead, the hold-off timer will be started. When the hold-off timer expires, the system checks whether a defect still exists on the trail that started the timer. If it does, that defect will be reported to protection switching. Range: 0 to 10000 ms in increments of 100 ms, for example, a value of 500 implies 500 milliseconds. When a fault condition is cleared, the traffic channel reverts after the expiry of a WTR timer (if no fault condition is present). This timer is used to avoid toggling protection states in case of intermittent defects. Range: 1 to 12 minutes. Example console#show ethernet ring g8032 profile Ethernet ring profile name p1 WTR interval 8 minutes Guard interval 30 milliseconds Holdoff interval 0 milliseconds Revertive mode Disabled Layer 2 Switching Commands 511