Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 790

• rate-percent - Data rate expressed as percentage of the supported maximum rate on the link (Range: 1 to 100). • burstsize-Burst size in kilobits per seconds (Kbps). (Range 1-128) • excess-burstsize-Excess burst size in kilobits per seconds (Kbps). (Range 1-128) • action-The action to take according to the color. Select one: - drop: Drop the packet. - set-prec-transmit ip-prec: Remark the IP precedence in the packet to ip-prec and transmit. (Range 0-7) - set-dscp-transmit dscp-val: Remark the DSCP in the packet to dscp- val and transmit. (Range 0-63) - set-cos-transmit 802.1p-priority: Remark the 802.1p priority in the packet to 802.1p-priority and transmit. (Range 0-7) - transmit: Transmit the packet unmodified. Default Configuration There no default configuration for this command. Command Modes Policy-Class-Map Configuration mode User Guidelines An srTCM meters a traffic stream and colors packets according to three parameters: Committed Information Rate (CIR), Committed Burst Size (CBS), and Peak Burst Size (PBS). A packet is colored red if it exceeds the CBS and the PBS, yellow if it exceeds the CBS, but not the PBS, and green if it exceeds neither. An srTCM is useful in situations where only the length of the burst, but not the peak rate, determines the service assignment. The CIR is measured in Kbps, the CBS in Kbytes, and the PBS in Kbytes. It is recommended that the CBS and PBS be configured to be larger than the largest expected IP packet. A class command in policy-map mode must be issued for an existing class-map before entering this command. Layer 2 Switching Commands 790