Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 2277

• owner_string-The identity string for the receiver. A receiver is not enabled until the owner string is assigned. The default is an empty string. The identity string must be set before assigning a receiver to a sampler or poller. (Range: 1-127 characters). • rcvr_timeout-The time, in seconds, remaining before the sampler or poller is released and stops sending samples to the receiver. Setting a value of 0 for the timeout value permanently configures the sflow receiver. Use the no form of the command to remove permanently configured receivers. A management entity wanting to maintain control of the sampler is responsible for setting a new value before the old one expires. (Range: 0-2147483647 seconds). • port-The destination Layer4 UDP port for sFlow datagrams. (Range: 1-65535). Default Configuration No receivers are configured by default. The default IP address is 0.0.0.0 The default maximum datagram size is 1400. The default owner string is the empty string. The default receiver timeout is 0. The default destination port is 6343. Command Mode Global Configuration mode. User Guidelines An sflow destination entry must have an owner assigned in order for polling or sampling to be operational. The last set of command parameters are optional in the no form of the command. Sflow commands with a timeout value supplied do not show in the running config. Because the timer is actively running, the command is ephemeral and is therefore not shown in the running config. Entering an sflow command with a notimeout parameter will cause the sflow configuration to be shown in the running config. Switch Management Commands 2277