Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 288

wizard, and enter CLI mode to manually configure the switch. You must respond to the next question to run the setup wizard within 60 seconds, otherwise the system will continue with normal operation using the default system configuration. Note: You can exit the setup wizard at any point by entering [ctrl+z]. Would you like to run the setup wizard (you must answer this question within 60 seconds)? (y/n) Regardless of if the administrator runs or does not run the Easy Setup wizard and if the SupportAssist application is installed: eula-consent support-assist accept is entered into the running-config if the SupportAssist EULA Accept file exists on the management unit in the stack and contains the 'EULA: Accepted' text. Regardless of whether the administrator runs or does not run the Easy Setup wizard and if the HiveAgent is installed: eula-consent hiveagent accept is entered into the running-config if the HiveAgent EULA Accept file exists on the management unit in the stack and contains the 'EULA: Accepted' text. The Easy Setup Wizard also prompts the user to configure a proxy server as follows: Step 5: Would you like to configure the address of an HTTPS proxy server used by the SupportAssist agent? [Y/N] y Enter the IPv4 or IPv6 address of the proxy server:192.168.0.3 Enter the port number used by HTTPS [443]: Enter the user name required to access the proxy server: Enter the password required to access the proxy server: This is the configuration information that has been collected: User Account setup = admin Password = ******** Out-of-band IP address = DHCP VLAN1 Router Interface IP = 0.0.0.0 0.0.0.0 Proxy Server Address: 192.168.0.3 Proxy Server Port: 443 Proxy Server User Name: Proxy Server Password: Using the CLI 288