Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 2371

hardware profile portmode {1x100g | 2x50g | 4x25g} no hardware profile portmode The available modes depend on the platform. N2200 only: • 1x40g: Configure the port as a single 40G port using four lanes. • 4x10g: Configure the port as four 10G ports, each on a separate lane. N3200 only: • 1x100g: Configure the port as a single 1x100G port using one lane. • 2x50g: Configure the port as two 50G ports, each on a separate lane. AN is not supported. • 4x25g: Configure the port as a four 25G ports, each on a separate lane. • The 25G ports may also operate at 10G speeds. Default Configuration • By default, 40G ports are configured in 1x40G stacking mode. • By default, 100G ports are configured in 2x50G stacking mode. Command Mode Interface (Ethernet) Configuration mode User Guidelines This command can only be executed on a 40G or 100G Ethernet interface that supports the expandable ports feature. Entering this command on any of the 4x10G, 2x50G, or 4x25G Ethernet interfaces (or any non-Ethernet port) will give an error. Entering the command on a non-expandable type of interface will give an error. When an expandable port is configured to operate in Ethernet mode, a breakout cable may be used to connect to other switches or hosts. When the stack port is configured in Ethernet mode, the stack ports and the non-configured Ethernet ports show as detached in the output of the show interfaces status command. For example, if the port is configured as 100G Ethernet, the two stack ports, the 2x50G Ethernet ports, and the 4x25G Ethernet ports show as detached. Likewise, when the port is configured in stack mode, all of the associated Ethernet ports will show as detached. Switch Management Commands 2371