Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1857

Default Configuration This command has no default configuration. Command Mode User Exec, Privileged Exec mode, Global Configuration mode and all Configuration submodes, VRF Configuration User Guidelines Some of the information below displays only if you enable OSPF and configure certain features. The following fields may be displayed: Field Description Router ID A 32-bit integer in dotted decimal format identifying the router about which information is displayed. This is a configured value. OSPF Admin Mode Shows whether OSPF is administratively enabled or disabled. External LSDB Limit Shows the maximum number of non-default external LSAs entries that can be stored in the link-state database. Exit Overflow Interval Shows the number of seconds that, after entering OverflowState, as defined by RFC 1765, a router will attempt to leave OverflowState. AutoCost Ref BW The configured autocost reference bandwidth. This value is used to determine the OSPF metric on its interfaces. The reference bandwidth is divided by the interface speed to compute the metric. Default Passive Setting When enabled, OSPF interfaces are passive by default. Maximum Paths Shows the maximum number of paths that OSPF can report for a given destination. Default Metric Default metric for redistributed routes. Default Route Advertise When enabled, OSPF originates a type 5 LSA advertising a default route. Always When this option is configured, OSPF only originates a default route when the router has learned a default route from another source. Layer 3 Routing Commands 1857