Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1787

Syntax Description This command has no arguments or keywords. Default Configuration There is no default configuration for this command. Command Mode User Exec, Privileged Exec modes, Global Configuration mode and all Configuration submodes User Guidelines The VRF identified in the parameter must have been previously created or an error is returned. The VRF parameter is only available on the N3200-ON series switch. Some of the information below displays only if you enable OSPF and configure certain features. The following fields may be displayed: Field Router ID OSPF Admin Mode RFC 1583 Compatibility External LSDB Limit Exit Overflow Interval Description A 32-bit integer in dotted decimal format identifying the router about which information is displayed. This is a configured value. Shows whether OSPF is administratively enabled or disabled. This configuration option controls the preference rules used when choosing among multiple external LSAs advertising the same destination. When enabled, the preference rules remain those specified by RFC 1583. When disabled, the preference rules are those stated in Section 16.4.1 of RFC 2328. These rules prevent routing loops when external LSAs for the same destination have been originated from different areas. Shows the maximum number of non-default external LSAs entries that can be stored in the link-state database. Shows the number of seconds that, after entering OverflowState, as defined by RFC 1765, a router will attempt to leave OverflowState. Layer 3 Routing Commands 1787