Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1122

network services behind the NAS. The voice and data domains are separated. Once the VM Controller is authenticated, it allows traffic from all the VMs hosted by the VM Controller. • single-host-Only allow a single authenticated device access to the network. No other hosts are allowed access to the network. Access is enforced via the MAC address of the authenticating host. The authenticated host must de-authenticate to allow a different host to authenticate. Shutting down the port de-authenticates any authenticated hosts. Use switchport mode general to support RADIUS VLAN assignment for the authenticating host. On a Switchport Access port in Multi-Auth mode, Single-Host and MultiDomain modes, the data client is allowed access only if it's VLAN matches the port's access VLAN. Command History Syntax added in version 6.6 firmware. Command updated in version 6.7 MR firmware. Example The following example globally configures an interface to allow a single host to authenticate. console(config)# authentication host-mode single-host authentication max-users Use the authentication max-users command in Interface Configuration mode to set the maximum number of clients supported on the port when multi-auth host mode is enabled on the port. Use the no version of the command to reset the maximum number of clients supported on the port to the default. Syntax authentication max-users users no authentication max-users Security Commands 1122