Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1401

• Peer is detected • Peer is not detected • Multiple peers are detected The following fields are displayed. Field Description Remote Address The neighbor's IPv6 address. If this is a link local address, the next line indicates the scope of the address. Remote AS The neighbor's autonomous system number Peer ID The neighbor's BGP router ID Peer Admin Status START or STOP Peer State The adjacency state of this neighbor Peer Type The type of peer Listen Range The ports that are being listened to. Local Port TCP port number on the local end of the connection Remote Port TCP port number on the remote end of the connection Connection Retry Interval How long BGP waits between connection retries Neighbor Capabilities Optional capabilities reported by the neighbor, recognized and accepted by this router. Codes listed in the show output are as follows: • MP: Multiprotocol • RF: Route Refresh This version of Dell Networking does not support any multiprotocol AFI/SAFI pairs other than IPv4 unicast. The presence of this capability does not imply otherwise. IPv4 Unicast Support Indicates whether IPv4 unicast routes can be exchanged with this peer. Both indicates that IPv4 is active locally and the neighbor indicated support for IPv4 unicast in its OPEN message. Sent indicates that IPv4 unicast is active locally, but the neighbor did not include this AFI/SAFI pair in its OPEN message. IPv4 unicast is always enabled locally and cannot be disabled. Layer 3 Routing Commands 1401