Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1356

User Guidelines By default, a neighbor-specific default has no MED and the Origin is IGP. Attributes may be set using an optional route map. A neighbor-specific default is only advertised if the Adj-RIB-Out does not include a default learned by other means, either from the default-information originate (BGP Router Configuration) command or a default learned from a peer. This type of default origination is not conditioned on the presence of a default route in the routing table. This form of default origination does not install a default route in the BGP routing table (it will not appear in the show ip bgp command), nor does it install a default route in the Adj-RIB-Out for the update group of peers so configured (it will not appear in the show ip bgp neighbors advertised-routes command). Origination of the default route is not subject to a prefix filter configured with the command distribute-list prefix out. A route map may be configured to set attributes on the default route sent to the neighbor. If the route map includes a match ip-address term, that term is ignored. If the route map includes match community or match as-path terms, the default route is not advertised. If there is no route map with the route map name given, the default route is not advertised. The VLAN interface must also be specified if a link-local address is specified. Command History Introduced in version 6.2.0.1 firmware. Command mode updated in version 6.8 firmware. Example console(config-router-af)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan 10 default-originate neighbor description Use this command to record a text description of a neighbor. The description is informational and has no functional impact. Syntax neighbor {ip-address | ipv6-address [interface interface-id] | autodetect interface interface-id} description text Layer 3 Routing Commands 1356