Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1390

Command Mode Route Map Configuration mode User Guidelines The route target (RT) extended community attribute is configured with the rt keyword. This attribute is used to identify VRFs that may receive routes that are tagged with the configured route target. Configuring the route target extended attribute with a route allows that route to be placed in the per-site forwarding tables that are used for routing traffic that is received from corresponding sites. Only one route target can be specified in a single set extcommunity rt command. To specify more than one route target, issue the command again with the additive keyword. By default, specifying route targets causes the system to replace existing route targets with the new route targets, unless the additive keyword is used. The use of the additive keyword causes the system to add the new route targets to the existing route target list, but does not replace any existing route targets. Command History Introduced in version 6.3.0.1 firmware. Command updated in version 6.6 firmware. Example The following example shows how to set the extended community attribute for route target with route-maps. (R1)(Config)# ip extcommunity-list 10 permit rt 1:1 (R1)(config)# route-map SEND_OUT permit 10 (R1)(config-route-map)# match extcommunity 13 (R1)(config-route-map)# set extcommunity rt 10:10 additive (R1)(config-route-map)# exit set extcommunity soo Use the set extcommunity soo command to set BGP extended community attributes for the site of origin. Use the no form of the command to remove the extended community attributes for the site of origin. NOTE: This command is effective only if BGP is running on the router. Layer 3 Routing Commands 1390