Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1443

User Guidelines If the vrf-name argument is specified, information pertaining to that VRF is displayed. The following information is displayed. Fields Delta T Phase Upd Grp GenId Reason Peer Duration Adds Mods Dels Description How long since the decision process was run. hours:minutes:seconds if the elapsed time is less than 24 hours. Otherwise, days:hours. The phase of the decision process that was run. Outbound update group ID. Only applies when phase 3 is run. Generation ID of BGP routing table when decision process was run. The generation ID is incremented each time phase 2 of the decision process is run and when there is a change to the status of aggregate addresses. The event that triggered the decision process to run. Phase 1 of the decision process can be triggered for a specific peer when a peer's inbound routing policy changes or the peer is reset. When phase 1 is run for a single peer, the peer's IP address is given. How long the decision process took, in milliseconds. The number of routes added. For phase 1, this is the number of prefixes that pass inbound policy and are added to the Accept-RIB-In. For phase 2, this is the number of routes added to the BGP routing table. For phase 3, this is the number of prefixes added to the update group's Adj-RIB-Out. The number of routes modified. Always 0 for phase 1. The number of routes deleted. Always 0 for phase 1. Command History Introduced in version 6.2.0.1 firmware. Updated in version 6.3.0.1 firmware. Layer 3 Routing Commands 1443