Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 757

Syntax conform-color {class-map-name} [exceed-color {class-map-name}] Default Configuration This command has no default configuration. Command Mode Policy-Class-Map Configuration mode User Guidelines This command must be preceded by a police command. If the conform-color command is not entered, the police algorithm uses the color-blind version, meaning in the incoming color is ignored. The conform-color command can be used with any of the three police algorithms. In the simple algorithm, only the conform color class can be configured. The conform color class pre-colors packets as green prior to metering. Non-conforming packets are pre-colored red prior to metering. With the single-rate and two-rate police algorithm, the conform color class pre-colors packets as green and the exceed color class precolors packets as yellow. Non-conforming packets are pre-colored red. Percolored packets are then metered and re-colored based upon the meter parameters. Color conforming classes must be one of the following types: • Primary COS • Secondary COS • DSCP • IP Precedence This includes both the input and color aware classes. The conform color class may not be the same as the input class, nor may the match criteria be of the same type. The input class map may have a match type of "any." The exceed color class may only be specified for the two-rate police algorithm. Layer 2 Switching Commands 757