Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 283

Terminal Paging The default terminal width and length for CLI displays is 79 characters and 25 lines, respectively. The length setting is used to control the number of lines the CLI will display before it pauses. For example, the CLI pauses at 24 lines and prompts the user with the --More-- or (q)uit prompt on the 25th line. The CLI waits for the user to press either or or any other key. If the user presses any key other than or , the CLI shows the next page. A key stops the display and returns to the CLI prompt. The key advances the display by one line. Use the terminal length command to change the number of lines displayed in a page. A terminal length of 0 disables pagination. This option is not recommended for serial console speeds of less than 115200. Boot Message The boot message is a system message that is not user-configurable and is displayed when the system is booting. To start the normal booting process, select item 1 in the Boot Menu. The following is a sample log for booting information. Select startup option within 5 seconds, else Operational Code will start automatically... Operational Code Startup -- Main Menu 1 - Start Operational Code 2 - Display Boot Menu Select (1, 2)# active = /dev/mtd7 Extracting Operational Code from .stk file...done. Loading Operational Code...done. Decompressing Operational Code...done. Scanning devshell symbols file... 47544 symbols, loading... Done. PCI unit 0: Dev 0xb842, Rev 0x02, Chip BCM56842_A0, Driver BCM56840_B0 SOC unit 0 attached to PCI device BCM56842_A0 Adding BCM transport pointers Configuring CPUTRANS TX Configuring CPUTRANS RX Aug 26 08:18:23 0.0.0.0-1 General[72162340]: bootos.c(166) 4 %% Event(0xaaaaaaaa) started! Using the CLI 283