Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 961

This example shows how to enable dot1x accounting to RADIUS server for start, interim and stop reports. Interim reports are sent every 60 minutes. (console)#configure (console-config)#aaa accounting dot1x default start-stop radius (console-config)#aaa accounting update periodic 60 The following shows an example of the no version of the command. (console)#configure (console-config)#aaa accounting commands userCmdAudit stop-only tacacs (console-config)#no aaa accounting commands userCmdAudit (console-config)#exit aaa accounting delay-start Use the aaa accounting delay-start command to delay the sending of AcctStart packets to RADIUS accounting server(s). Syntax aaa accounting delay-start [extended-time delay_value] no aaa accounting delay-start • delay_value-The maximum number of seconds to wait before sending the Acct-Start packet to the RADIUS accounting server. Range: 1 to 300 seconds. Default Configuration By default, the switch will wait up to the maximum of maximum number of retries (radius server retransmit) multiplied by the timeout (radius server timeout). Command Mode Global Configuration mode User Guidelines Dell recommends that a fixed time be configured for the delay in order to ensure timely delivery of Acct-Start packets to the RADIUS accounting server. Acct-Interim and Acct-Stop messages are not delayed, nor are any Authentication messages delayed by configuration of this command. Security Commands 961