Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1386

Syntax redistribute {ospf [match {[internal][external 1] [external 2] [nssa-external 1] [nssa-external 2]}] | rip | connected | static} [metric metric-value] [route-map map-tag] no redistribute {ospf [match {[internal][external 1] [external 2] [nssaexternal 1] [nssa-external 2]}] | rip | connected | static} [metric metricvalue] [route-map map-tag] • ospf, rip, connected, static-A source of routes to redistribute. • metric metric-value-(Optional) When this option is specified, BGP advertises the prefix with the Multi Exit Discriminator path attribute set to the configured value. If this option is not specified, but a default metric is configured for BGP (default metric command), the MED is set to the default metric. If both a default metric and a metric value are not configured, the prefix is advertised without a MED attribute. • match-(Optional) By default, if BGP is configured to redistribute OSPF routes (redistribute ospf command), BGP only redistributes internal routes (OSPF intra-area and inter-area routes). Use of the match option configures BGP to also redistribute specific types of external or internal routes, or to disable redistribution of OSPF routes. The match option is only valid for OSPF originated routes. Successive redistribute commands are additive. Use the no form of the command to disable redistribution of a route source. • route-map map-tag-(Optional) A route map can be used to filter redistributed routes by destination prefix using a prefix list. Default Configuration BGP redistributes no routes by default. When BGP redistributes OSPF routes, it redistributes only internal routes unless the match option specifies external routes. Command Mode IPv4 Address Family Configuration mode, IPv6 Address Family Configuration mode Layer 3 Routing Commands 1386