Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1568

Actions in the MAC ACL configuration are applied with other actions configured in the route map. When a MAC ACL referenced by a route map is removed, the route map rule is also removed. Example console(config-route-map)#match mac-list mac-test route-map Use this command to create a policy based route map. Use the no form of this command to delete a route map or one of its statements. Syntax route-map map-tag [permit | deny] [sequence-number] no route-map map-tag [permit | deny] [sequence-number] • map-tag-Text name of the route map. Route maps with the same name are grouped together in order of their sequence numbers. A route map name may be up to 32 characters long and comprised of any printable character except a question mark. Enclose the map-tag in quotes to embed blanks in the name. • permit-(Optional) Permit routes that match all of the match conditions in the route map. • deny-(Optional) Deny routes that match all of the match conditions in the route map. Packets matching deny routes use the routing table. • sequence-number-(Optional) An integer used to order the set of route maps. Route maps are ordered from lowest to greatest sequence number, with lower sequence numbers being considered first. If no sequence number is specified, the system assigns a value ten greater than the last statement in the route map. The range is 0 to 65,535. Default Configuration No route maps are configured by default. If no permit or deny tag is specified, permit is the default. Command Mode Global Configuration mode Layer 3 Routing Commands 1568