Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1421

User Guidelines Phase 1 of the decision process reacts to UPDATE messages received from peers, determining what new routes are accepted, and deleting withdrawn routes from the Adj-RIB-In. Phase 3 is run independently for each outbound update group and determines which routes are advertised to neighbors in each group. Each entry in the table shows statistics for one phase of the decision process. The table shows the 20 most recent decision process runs, with the most recent information at the end of the table. The following table describes the significant fields shown in the display. Field Delta T Phase Upd Grp GenId Reason Peer Duration Adds Mods Dels Description How long since the decision process was run. Displays hours:minutes:seconds if the elapsed time is less than 24 hours. Otherwise, the display is days:hours. Which phase of the decision process was run. Outbound update group ID. Only applies when phase 3 is run. Generation ID of BGP routing table when decision process was run. The generation ID is incremented each time phase 2 of the decision process is run and when there is a change to the status of aggregate addresses. The event that triggered the decision process to run. Phase 1 of the decision process can be triggered for a specific peer when a peer's inbound routing policy changes or the peer is reset. How long the decision process took, in milliseconds. The number of routes added. For phase 1, this is the number of prefixes that pass inbound policy and are added to the Accept-RIB-In. For phase 3, this is the number of prefixes added to the update group's Adj-RIBOut. The number of routes modified. Always 0 for phase 1. The number of routes deleted. Always 0 for phase 1. Command History Command introduced in version 6.8 release. Layer 3 Routing Commands 1421