Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 707

no lacp system-priority • value - System priority value. (Range: 1-65535) Default Configuration The default system priority value is 1. Command Mode Global Configuration mode User Guidelines Per IEEE 802.1AX-2008 Section 5.6, ports are selected for aggregation by each switch based upon the port priority assigned by the switch with the higher system priority, starting with the highest priority port of the switch with the higher switch priority, and working downward through the ordered list of port priority values for the ports. The system priority of each switch is an eight octet binary number, formed by using the configured system priority as the two most significant octets and the switch id (MAC address) as the least significant six octets. For a given switch and link aggregation partner, the switch with the numerically lower value of system priority has the higher priority. The selection algorithm is reapplied upon changes in the membership of the port channel (for example, if a link fails, or if a new link joins the group) and any subsequent changes to the set of active links are made according to the above algorithm. Example The following example configures the system priority to 120. console(config)#lacp system-priority 120 lacp timeout Use the lacp timeout command to assign an administrative LACP timeout. To reset the administrative LACP timeout to the default, use the no form of this command. Layer 2 Switching Commands 707