Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 519

green-mode eee tx-wake-time 0-65535 no green-mode eee {tx-idle-time|tx-wake-time} Default Configuration By default, the transmit idle time is 600 micro-seconds and the transmit wake time is 8 micro-seconds. Command Mode Interface Configuration mode, Interface Range Configuration mode User Guidelines The tx-idle-time parameter sets the amount of time the link must be idle before transitioning to the low power idle state. The tx-wake-time configures the delay before transitioning to the active state (and transmitting the pending packet) after transmitting a wake symbol to the link partner. The transmit idle time and transmit wake time are configured in micro-seconds. The default values are recommended unless there is good reason to adjust them. Excessive wake times may cause link congestion. Excessive idle times will reduce the savings from low power idle mode. This command is available in Ethernet interface configuration mode for copper ports that are EEE capable. Configuring the values on interfaces that do not support EEE will return an error. Command History Syntax added in 6.4 release. clear green-mode statistics Use the clear green-mode statistics command to clear: • The EEE LPI event count, and LPI duration • The EEE LPI history table entries • The Cumulative Power savings estimates for a specified interface or for all the interfaces based upon the argument. Layer 2 Switching Commands 519