Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1327

• *- Reset adjacency with every BGP peer. • as-number- Only reset adjacencies with BGP peers in the given autonomous system. The router's autonomous system number in asplain format. Dell Networking BGP supports four byte AS numbers, in the range of 0-429496729. • ipv4-address-Only reset the adjacency with a single specified peer with a given IPv4 peer address. • ipv6-address [interface interface-id]-Only reset the adjacency with a single specified peer with a given IPv6 peer address. If the interface-id is given, only reset the adjacency on the specified interface. The interface id must be a routing interface (a routed VLAN identifier). An adjacency that is formed with the auto-detect feature cannot be reset with the command. • listen range - Reset all adjacencies that are included in the listen subnet range. • soft-BGP resends all updates to the neighbors and reprocesses updates from the neighbors. • in | out-If the in keyword is given, updates from the neighbor are reprocessed. If the out keyword is given, updates are resent to the neighbor. If neither keyword is given, updates are reprocessed in both directions. Default Configuration There is no default configuration. Command Mode Privileged Exec mode User Guidelines Soft inbound reset causes BGP to send a Route Refresh request to each neighbor being reset. If a neighbor does not support the Route Refresh capability, the updated policy is applied to routes previously received from the neighbor. When a change is made to an outbound policy, BGP schedules an outbound soft reset to update neighbors according to the new policy. This command applies to routes for all address families. Layer 3 Routing Commands 1327