Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1387

User Guidelines The distribute-list out command can also be used to filter redistributed routes by prefix. Either a redistribute route map or a distribute list may be configured, but not both. Successive invocations of the redistribute command are additive. The redistribute command does not overwrite previous redistribute command configuration or the default configuration. Use the no redistribute command to remove the redistribution of internal or external routes. A default route cannot be redistributed unless the default-informationoriginate command is given. The configured metric value is specific to the routes distributed. Use the default-metric command to configure a default metric for all redistributed routes. In IPv6 address family configuration mode, the syntax and behavior is the same as for IPv4, except that Dell Networking does not support RIP for IPv6. In conformance with RFC 1475, information learned via BGP from peers within the same AS is not redistributed to OSPF. Command History Introduced in version 6.2.0.1 firmware. Example console(config-router-af-ipv4)#redistribute rip route-target Use the route-target command to create a list of export, import, or both route target (RT) extended communities for the specified VRF instance. Use the no form of the command to remove the route target from a VRF instance. Syntax route-target {export | import | both} rt-ext-comm no route-target {export | import | both} rt-ext-comm • export - Exports routing information to the target VPN extended community. Layer 3 Routing Commands 1387