Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 2118

• subnet-mask - Subnet mask of the interface • prefix-length - Length of the prefix. Must be preceded by a forward slash (/). (Range: 1-30 bits) • secondary - Indicates the IP address is a secondary address. Default Configuration The N1108EP-ON/N1500/N2200-ON default IPv4 address assignment method is DHCP on VLAN 1. The N3200-ON default IPv4 address assignment method on VLAN 1 is none, and the default address assignment on the out-of-band port is DHCP. See the ip address (Out-of-band) command for more information. Use the no interface vlan command to remove an IP routing interface, clear any bound IP address and set the address assignment method to the default. Command Mode Interface Configuration (VLAN, Loopback) mode User Guidelines This command also implicitly enables the VLAN or loopback interface for routing (i.e. as if the user had issued the 'routing' interface command). By default, configuring an IP address on a VLAN enables in-band management for interfaces configured with that VLAN. Setting up an IP address on VLAN 1 enables switch management on all in-band interfaces except for those where VLAN 1 is specifically excluded. The ip address none command clears the currently assigned IPv4 address and sets the IP address configuration method to none. The no ip address command clears the currently assigned IPv4 address and sets the IP address configuration method to the default (whatever the default is). Use the show ip interface {management|vlan } command to display the configured IP addresses. A physical or loopback interface must be made a member of the VLAN in order for the address configuration to be bound to an interface. A VLAN interface configured for DHCP address assignment will send the following text string in DHCP Option 60 of the DHCPDISCOVER message to assist the DHCP server in identification of the switch: "Dell;