Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 429

loss on other ports that are not congested or flow controlled. See http://www.ieee802.org/3/cm_study/public/september04/thaler_3_0904.pdf for more information. Example The following example enables Gigabit port 2 on stack member 1 for configuration. console(config)# interface gigabitethernet 1/0/2 interface range Use the interface range command in Global Configuration mode to execute a command on multiple ports at the same time. NOTE: An additional form of this command enables configuring a range of VLANs. See interface range vlan. Syntax interface range {interface-range-specifier | interface-type all} • port-range-A list of valid ports to configure. Separate non-consecutive ports with a comma and no spaces; use a hyphen to designate a range of ports. For more detailed information, see Command line parameters are entered by the user to choose an individual value or range of values for the specific command. Command line parameters are not syntax or range checked until the carriage return is entered. In some cases, the user may need to enter special characters, most often in a string parameter such as a password or a label. Special characters are one of the following characters or a blank. In these cases, it may be necessary to enclose the entire string in double or single quotes for the command line parser to properly interpret the parameter.. The command line buffer parses up to the maximum number of command line characters possible in the port-range parameter. • port-type-Shows all interfaces of the specified type. Default Configuration This command has no default configuration. Layer 2 Switching Commands 429