Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 2097

Command Mode User Exec, Privileged Exec modes, Global Configuration mode and all Configuration submodes User Guidelines This command shows the DHCP status. Statistics are shown depending on the interface mode (relay, server, or client). The command output provides the following information for an interface configured in client mode. Not all fields will be shown for an inactive client. Term Mode State Server DUID T1 Time T2 Time Interface IAID Leased Address Preferred Lifetime Valid Lifetime Description Displays whether the specified interface is in Client, Relay, or Server mode. State of the DHCPv6 Client on this interface. The valid values are: INACTIVE, SOLICIT, REQUEST, ACTIVE, RENEW, REBIND, RELEASE. DHCPv6 Unique Identifier of the DHCPv6 Server on this interface. The T1 (in seconds) time as indicated by the DHCPv6 Server. T1 value indicates the time interval after which the address is requested for renewal. The T2 (in seconds) time as indicated by the DHCPv6 Server. T2 value indicates the time interval after which the Client sends Rebind message to the Server in case there are no replies to the Renew messages. An identifier for an identity association chosen by this Client. The IPv6 address leased by the DHCPv6 Server for this interface. The preferred life time (in seconds) of the IPv6 Address leased by the DHCPv6 Server. The valid life time (in seconds) of the IPv6 Address leased by the DHCPv6 Server. Switch Management Commands 2097