Dell N3200-ON Networking N-Series Switches CLI Reference Guide version 6.8.0 - Page 1402

IPv6 Unicast Support Indicates whether IPv6 unicast routes can be exchanged with this peer. Both and Sent have the same meaning as for IPv4. None indicates that neither the local router nor the peer has IPv6 enabled for this adjacency. Received indicates that the peer advertised the IPv6 unicast capability, but it is not enabled locally. IPv6 unicast is enabled locally using the neighbor activate command in address-family IPv6 configuration mode. RFC 5549 Support Shown if support for RFC 5549 is enabled and the BGP neighbor is peered over IPv6 network. Update Source The configured value for the source IP address of packets sent to this peer. This field is only included in the output if the update source is configured. Local Interface Address The IPv6 address used as the source IP address in packets sent to this neighbor. Configured Hold Time The time, in seconds, that this router proposes to this neighbor as the hold time Configured Keep Alive Time The configured KEEPALIVE interval for this neighbor. Negotiated Hold Time The minimum configured hold time and the hold time in the OPEN message received from this neighbor. If the local router does not receive a KEEPALIVE or UPDATE message from this neighbor within this interval of time, the local router drops the adjacency. This field is only shown if the adjacency state is OPEN CONFIRM or greater. Keep Alive Time The number of seconds between KEEPALIVE messages sent to this neighbor. This field is only shown if the adjacency state is OPEN CONFIRM or greater. Prefix Limit The maximum number of prefixes this router is willing to accept from this neighbor. Prefix Warning Threshold Percentage of the prefix limit that causes a warning message to be logged. Warning Only on Prefix Limit Whether to shutdown a neighbor that exceeds the prefix limit. TRUE if the event is logged without shutting down the neighbor. Layer 3 Routing Commands 1402