Dell OptiPlex GX260 User Guide - Page 38
AGP and DVI Adapter Cards: Dell OptiPlex GX260 Systems User's Guide, Removing an AGP/DVI Adapter Card - network driver
View all Dell OptiPlex GX260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Back to Contents Page AGP and DVI Adapter Cards Dell™ OptiPlex™ GX260 Systems User's Guide CAUTION: Before you begin any of the procedures in this section, follow the steps in "CAUTION: Safety Instructions." CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover. Your Dell™ computer provides a connector for an AGP or DVI adapter card. NOTE: The DVI adapter card works through your computer's integrated graphics. To control the adapter through your operating system, click the Start menu, click Control Panel, and then click the integrated graphics driver's userinterface icon. 1. Perform an orderly computer shutdown using the operating system menu. NOTICE: To disconnect a network cable, first unplug the cable from your computer, and then unplug it from the network wall jack. 2. Turn off any attached devices and disconnect them from their electrical outlets. 3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board. 4. Remove the computer stand, if it is attached. 5. Open the computer cover. Removing an AGP/DVI Adapter Card 1. Remove the filler bracket by raising the hinged lever and sliding the filler bracket up. Filler Bracket Removal 1 hinged lever 2 filler bracket 2. On the card clip, press the card clip lever toward the PCI card slot. 3. Pull the card up and out of the card clip.