HP 630n HP Jetdirect Print Servers - Administrator's Guide - Page 151
Novell/NetWare parameters, Table 8-11, Novell/NetWare
UPC - 808736806244
View all HP 630n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Table 8-10 IPX/SPX configuration information (continued) Message Description An error code and message is displayed if the print server is not ready. For more information, see Table 8-14 Error messages on page 143. PRIMARY FRAME TYPE Frame type selection. AUTO SELECT Automatically sense and limit to the first one detected. EN_8023 Limit to IPX over IEEE 802.3 frames. All others are counted and discarded. EN_II Limit to IPX over Ethernet frames. All others are counted and discarded. EN_8022 Limit to IPX over IEEE 802.2 with IEEE 802.3 frames. All others are counted and discarded. EN_SNAP Limit to IPX over SNAP with IEEE 802.3 frames. All others are counted and discarded. NETWORK FRAME TYPE Network column specifies the network number associated with a protocol frame type used for communication between a server and the HP Jetdirect print server. UNKNOWN Determining which network number to use. RCVD Frame Type column identifies the frame type used with the associated network number: EN_8023, EN_8022, EN_II, EN_SNAP. Unless a specific frame type is manually set, the print server automatically determines the protocol frame type by listening to the network data. DISABLED Frame type for that network is manually configured. RCVD column displays the packets received for each frame type. Novell/NetWare parameters Information in this section of the HP Jetdirect configuration page is described in Table 8-11 Novell/ NetWare configuration information on page 141. For error messages, see Table 8-14 Error messages on page 143. Table 8-11 Novell/NetWare configuration information Message Description STATUS Current Novell NetWare configuration status. READY Print server is awaiting data. DISABLED Manually disabled. INITIALIZING Registering the node address or name. Additional status messages might be displayed. An error code and message is displayed if the print server is not ready. For more information, see Table 8-14 Error messages on page 143. NODE NAME Queue Server Mode Print server name, which must match a valid print server on the appropriate NetWare file server. The default name is NPIXXXXXX, where XXXXXX is the last six digits of the LAN hardware (MAC) address. Remote Printer Mode Network printer name. The default name is NPIXXXXXX. NETWARE MODE Mode used by the HP Jetdirect print server. QUEUE SERVER Receives data directly from the queue. REMOTE PRINTER Print server emulates a Novell NetWare remote printer. (The printer number normally follows this parameter.) ENWW HP Jetdirect configuration page 141