HP 630n HP Jetdirect Print Servers - Administrator's Guide - Page 184

Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued) Menu item Sub-menu item Sub-menu item Values and Description No: Do not select this test. HTTP Test Check operation of HTTP by retrieving predefined pages from the device, and test the embedded Web server. Yes: Select this test. No: Do not select this test. SNMP Test Checks operation of SNMP communications by accessing predefined SNMP objects on the device. Yes: Select this test. No: Do not select this test. Data Path Test Identify data path and corruption problems on an HP postscript level 3 emulation device. Sends a predefined PS file to the device. However, the file does not print (paperless). Yes: Select this test. No: Do not select this test. Select All Tests Run all the embedded tests. Yes: Run all tests. No: Do not run all tests. Execution Time [H] Specify the length of time (in hours) that an embedded test runs, using a value from 1 to 60. If you select zero (0), the test runs indefinitely until an error occurs or the device is turned off. Data gathered from the HTTP, SNMP, and Data Path tests is printed after the tests complete. Execute No (default): Do not run the selected tests. Yes: Run the selected tests. Ping Test Test network communications. Sends link-level packets to a remote network host, then waits for an appropriate response. Dest Type Target device is an IPv4 or IPv6 node. Dest IPv4 The IPv4 address. Dest IPv6 The IPv6 address. Packet Size Size of each packet, in bytes, sent to the remote host. The minimum is 64 (default) and the maximum is 2048. Timeout Length of time, in seconds, to wait for a response from the remote host. The default is 1 and the maximum is 100. Count Number of ping test packets to send. Select a value from 1 to 100. Enter zero (0) to run the test continuously. Print Results Print the test results (if not running continuously). 174 Appendix C HP Jetdirect control panel menus (V.38.xx) ENWW