HP 630n HP Jetdirect Print Servers - Administrator's Guide - Page 83

Table 4-7 TCP/IP(v6) tab (continued) Item Description Select the Enable check box to use a manually configured IPv6. Clear this check box to disable the address. Enter the IPv6 address and its prefix length using the Address and Prefix length fields. If IPv6 address prefixes (for example, supplied by a router) are stored on the print server, you can select a prefix from the Prefix field, and then click Add to copy the prefix into the Address field. Then enter the remainder of the address. Config Precedence tab Specify the order of precedence of the print server configuration methods. For example, to ensure that IPv4 parameters configured by a TFTP server cannot be overwritten by a manual configuration method (such as the printer control panel, Telnet, or embedded Web server), you can indicate that TFTP takes precedence over manual configuration. The factory-default precedence order is indicated in the following table. Table 4-8 TCP/IP Config Precedence tab Item Description Configuration Methods Precedence of the configuration methods. The default precedence order is shown, where manual configuration has the highest priority. To change the order of the list, select an entry and use the up or down arrows to move it. Manual Use the printer control panel, Telnet, embedded Web server, installation and management software. TFTP Use a TFTP file from a TFTP server, typically identified during a BootP/DHCP configuration. DHCP/Bootp Use a BootP or DHCPv4 server. DHCPv6 Use a DHCPv6 server. Default: Factory default configuration. Reset to default scheme Reset the precedence table to the default sequence. Reinitialize Now Save the new precedence table, clear the configuration method to its factory-default setting, and restart the IP stack. Clear Previous Values and Reinitialize Now Save the new precedence table, clear the configuration method to its factory-default setting, clear current TCP/IP parameter settings, and restart the IP stack. Apply Cancel Click Apply to save the changes to the Configuration Methods precedence table. Depending on the changes made, you might need to turn the print server Off/On to implement. Click Cancel to cancel your changes to the precedence table. CAUTION: Clicking Cancel does not reverse changes made by the Reinitialize Now or Clear Previous Values and Reinitialize Now buttons. Example: To set all parameters configured through DHCP to Read-only, and allow manual configuration only of parameters that are not configured through DHCP, use the following steps: 1. Turn on the print server so that it obtains its DHCP configuration. ENWW Networking tab 73