HP 630n HP Jetdirect Print Servers - Administrator's Guide - Page 159

HP Jetdirect Security Security, Print Sec

Page 159 highlights

Table 8-14 Error messages (continued) Error Code and Message Description 65 DOWNLOAD NOT ALLOWED ON This print server does not allow firmware upgrade over a wireless network connection. WIRELESS 83 DISCONNECTING FROM SERVER Server shut down because of a configuration change or reset request. This message automatically clears after a few seconds, unless the printer is offline, is in an error state, or is servicing another I/O port or another network protocol. 84 DHCP LEASE TIMERS ADJUSTED The print server detected a DHCP lease error due to one of the following conditions: ● Renew time is less than 30 seconds. ● Rebind time is less than 52 seconds. ● Rebind time is less than, or equal to, the Renew time. ● Lease duration is less than, or equal to, the Rebind time. F1 TRYING TO CONNECT TO SERVER The HP Jetdirect print server is attempting connection to the NetWare server(s). This is a normal message. Wait until the connection is established or another status message appears. F2 TFTP IN PROGRESS The print server is attempting to use TFTP to obtain TCP/IP configuration settings over the network. F3 BOOTP/RARP IN PROGRESS The print server is attempting to use BootP or RARP to obtain TCP/IP configuration settings over the network. F4 BOOTP/DHCP IN PROGRESS The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration settings over the network. HP Jetdirect Security page If the HP Jetdirect print server supports IPsec, you can print an enhanced Security page from the HP Jetdirect menu that is accessed through the printer control panel. The following figure shows a typical Security page: NOTE: This section describes a typical security page. The actual security page content depends on the HP Jetdirect product and the firmware version. To print the HP Jetdirect Security Page: 1. On the printer control panel, navigate to the HP Jetdirect menus. 2. In the HP Jetdirect menus, locate and select the Security menu item. 3. In the Security menu, locate and select Print Sec Page . (This option is displayed only if IPsec is supported by the print server.) 4. Click Yes to print the security page. ENWW HP Jetdirect Security page 149

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202

Error Code and Message
Description
65 DOWNLOAD NOT ALLOWED ON
WIRELESS
This print server does not allow firmware upgrade over a wireless network connection.
83 DISCONNECTING FROM
SERVER
Server shut down because of a configuration change or reset request. This message
automatically clears after a few seconds, unless the printer is offline, is in an error state,
or is servicing another I/O port or another network protocol.
84 DHCP LEASE TIMERS
ADJUSTED
The print server detected a DHCP lease error due to one of the following conditions:
Renew time is less than 30 seconds.
Rebind time is less than 52 seconds.
Rebind time is less than, or equal to, the Renew time.
Lease duration is less than, or equal to, the Rebind time.
F1 TRYING TO CONNECT TO
SERVER
The HP Jetdirect print server is attempting connection to the NetWare server(s). This
is a normal message. Wait until the connection is established or another status message
appears.
F2 TFTP IN PROGRESS
The print server is attempting to use TFTP to obtain TCP/IP configuration settings over
the network.
F3 BOOTP/RARP IN PROGRESS
The print server is attempting to use BootP or RARP to obtain TCP/IP configuration
settings over the network.
F4 BOOTP/DHCP IN PROGRESS
The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration
settings over the network.
HP Jetdirect Security page
If the HP Jetdirect print server supports IPsec, you can print an enhanced Security page from the
HP Jetdirect menu that is accessed through the printer control panel. The following figure shows a typical
Security page:
NOTE:
This section describes a typical security page. The actual security page content depends on
the HP Jetdirect product and the firmware version.
To print the
HP Jetdirect Security Page
:
1.
On the printer control panel, navigate to the HP Jetdirect menus.
2.
In the HP Jetdirect menus, locate and select the
Security
menu item.
3.
In the
Security
menu, locate and select
Print Sec Page
. (This option is displayed only if IPsec is
supported by the print server.)
4.
Click
Yes
to print the security page.
Table 8-14
Error messages (continued)
ENWW
HP Jetdirect Security page
149