HP 630n HP Jetdirect Print Servers - Administrator's Guide - Page 158

A Turn Printer Off / On, 5d Dhcp Lease Duration Too

Get HP 630n - JetDirect Gigabit EN Print Server PDF manuals and user guides
UPC - 808736806244
View all HP 630n manuals
Add to My Manuals
Save this manual to your list of manuals

Page 158 highlights

Table 8-14 Error messages (continued) Error Code and Message Description 4F TFTP REMOTE ERROR TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed. The remote host sent a TFTP error packet to the print server. 50 TFTP LOCAL ERROR TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed. The local print server encountered an inactivity timeout or excessive retransmission situation. 51 TFTP RETRIES EXCEEDED Retry limit exceeded when transferring the TFTP configuration file from the host to the HP Jetdirect print server. 52 BAD BOOTP/DHCP REPLY Error detected in the BOOTP or DHCP reply received by the HP Jetdirect print server. The reply contains insufficient data in the UDP datagram for the minimum BOOTP/ DHCP header of 236 bytes, has an operation field that is not BOOTPREPLY(0X02), has a header field that does not match the print servers hardware address, or contains a UDP source port that is not the BOOTP/DHCP server port (67/udp). 53 BAD BOOTP TAG SIZE Tag size in a vendor-specific field in the BOOTP reply is either 0, or greater than the remaining number of unprocessed bytes in the vendor-specified area. 54 BOOTP/RARP IN PROGRESS Print server is obtaining its basic IP configuration information through BOOTP/RARP. 55 BOOTP/DHCP IN PROGRESS HP Jetdirect print server is obtaining its basic IP configuration information through BOOTP/DHCP (no errors detected). 56 DHCP NAK Print server received a negative acknowledgement message from the DHCP server in response to a configuration request. 57 UNABLE TO CONNECT DHCP The HP Jetdirect print server received IP parameters from a DHCP server, but SVR communication with the server is lost. Check status of the DHCP server. If an infinite lease is assigned, the print server uses the IP address of the most recent DHCP server. Operation can degrade until a DHCP server responds. 58 POSTSCRIPT MODE NOT SELECTED Printer does not support AppleTalk or AppleTalk extensions. 59 INCOMPLETE F/W - MUST DOWNLOAD Currently downloading firmware to the HP Jetdirect print server, or the download did not complete properly. 5A TURN PRINTER OFF / ON Firmware download is complete. Turn the HP Jetdirect print server off and then on. 5C DHCP BAD REPLY Bad reply received from the DHCP server. Check your DHCP server settings for this print server. 5D DHCP LEASE DURATION TOO DHCP lease times for this print server's TCP/IP configuration settings are too short. Re- SHORT configure the DHCP lease times on the DHCP server. 5E DHCP LEASE RELEASED Lease parameters for DHCP, including the IP address, were released through a manual configuration method, such as the printer's control panel. 5F WINS REGISTRATION FAILED Cannot register the print server's name on the WINS server. Check for duplicate names, or verify the WINS server configuration. 61 AUTO IP CONFIGURED Cannot retrieve an IP address over the network. The print server defaults to an IP address using link-local addressing in the form 169.254.x.x. 62 DEFAULT IP CONFIGURED Cannot retrieve an IP address over the network. The print server defaults to a legacy IP address 192.0.0.192. 63 AUTO IP IN PROGRESS The print server is automatically assigning an IP address using link-local addressing in the form 169.254.x.x. 64 INVALID PASSWORD An invalid password was specified through TFTP. Verify that the password consists of a maximum of 16 printable characters. 148 Chapter 8 HP Jetdirect configuration pages ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
Error Code and Message
Description
4F TFTP REMOTE ERROR
TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed.
The remote host sent a TFTP error packet to the print server.
50 TFTP LOCAL ERROR
TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed.
The local print server encountered an inactivity timeout or excessive retransmission
situation.
51 TFTP RETRIES EXCEEDED
Retry limit exceeded when transferring the TFTP configuration file from the host to the
HP Jetdirect print server.
52 BAD BOOTP/DHCP REPLY
Error detected in the BOOTP or DHCP reply received by the HP Jetdirect print server.
The reply contains insufficient data in the UDP datagram for the minimum BOOTP/
DHCP header of 236 bytes, has an operation field that is not BOOTPREPLY(0X02),
has a header field that does not match the print servers hardware address, or contains
a UDP source port that is not the BOOTP/DHCP server port (67/udp).
53 BAD BOOTP TAG SIZE
Tag size in a vendor-specific field in the BOOTP reply is either 0, or greater than the
remaining number of unprocessed bytes in the vendor-specified area.
54 BOOTP/RARP IN PROGRESS
Print server is obtaining its basic IP configuration information through BOOTP/RARP.
55 BOOTP/DHCP IN PROGRESS
HP Jetdirect print server is obtaining its basic IP configuration information through
BOOTP/DHCP (no errors detected).
56 DHCP NAK
Print server received a negative acknowledgement message from the DHCP server in
response to a configuration request.
57 UNABLE TO CONNECT DHCP
SVR
The HP Jetdirect print server received IP parameters from a DHCP server, but
communication with the server is lost. Check status of the DHCP server.
If an infinite lease is assigned, the print server uses the IP address of the most recent
DHCP server. Operation can degrade until a DHCP server responds.
58 POSTSCRIPT MODE NOT
SELECTED
Printer does not support AppleTalk or AppleTalk extensions.
59 INCOMPLETE F/W - MUST
DOWNLOAD
Currently downloading firmware to the HP Jetdirect print server, or the download did
not complete properly.
5A TURN PRINTER OFF / ON
Firmware download is complete. Turn the HP Jetdirect print server off and then on.
5C DHCP BAD REPLY
Bad reply received from the DHCP server. Check your DHCP server settings for this
print server.
5D DHCP LEASE DURATION TOO
SHORT
DHCP lease times for this print server's TCP/IP configuration settings are too short. Re-
configure the DHCP lease times on the DHCP server.
5E DHCP LEASE RELEASED
Lease parameters for DHCP, including the IP address, were released through a manual
configuration method, such as the printer's control panel.
5F WINS REGISTRATION FAILED
Cannot register the print server's name on the WINS server. Check for duplicate names,
or verify the WINS server configuration.
61 AUTO IP CONFIGURED
Cannot retrieve an IP address over the network. The print server defaults to an IP
address using link-local addressing in the form 169.254.x.x.
62 DEFAULT IP CONFIGURED
Cannot retrieve an IP address over the network. The print server defaults to a legacy
IP address 192.0.0.192.
63 AUTO IP IN PROGRESS
The print server is automatically assigning an IP address using link-local addressing in
the form 169.254.x.x.
64 INVALID PASSWORD
An invalid password was specified through TFTP. Verify that the password consists of
a maximum of 16 printable characters.
Table 8-14
Error messages (continued)
148
Chapter 8
HP Jetdirect configuration pages
ENWW