HP 630n HP Jetdirect Print Servers - Administrator's Guide - Page 65

Table 3-3 Telnet Commands and Parameters (continued) network-select (For HP Jetdirect products with a dual wired/wireless port. Specifies the active behavior of the print server.) ● Auto (default): Automatically detects whether a network cable is attached. If a network cable is not attached, only the IEEE 802.11g wireless port is active. If a network cable is attached, then only the IEEE 802.3 wired port is active. CAUTION: Do not plug a network cable into an active wired/wireless port if the network-select command is set to Auto. Wireless access will immediately terminate. ● Wired: Only the 802.3 wired port is active. ● Wireless: Only the 802.11g wireless port is active. link-type (For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000 Mbps) and communication mode (Full- or Half-Duplex). The available link-speed depends on the print server model. Select from the following communication modes: AUTO (default): Use auto-negotiation to configure the highest link speed and communication mode allowed. 1000FULL: 1000 Mbps, full-duplex operation. 100AUTO: Limit auto-negotiation to a maximum link speed of 100 Mbps. 100FULL: 100 Mbps, full-duplex operation. 100HALF: 100 Mbps, half-duplex operation. 10FULL: 10 Mbps, Full-duplex operation. 10HALF: 10 Mbps, half-duplex operation. usb-mode Communication mode over the USB port on the HP Jetdirect print server. ● Auto (default): Automatically negotiate and set the highest communication mode possible for the attached printer or device. ● MLC: HP proprietary (multiple logical channels) mode that allows multiple channels of simultaneous print, scan, and status communication. ● BIDIR: Standard connection that supports bi-directional communication between the printer and print server. ● UNIDIR: Standard connection in which data is transferred in one direction only (to the printer). usb-speed (Read-only parameter, USB 2.0 products only.) Auto-negotiated communication speed over the USB connection between the HP Jetdirect print server and the device. ● Full Speed: 12 Mbits/sec as specified in the USB v2.0 specifications, compatible with USB v1.1 specifications. ● Hi-Speed: 480 Mbits/sec for USB v2.0 devices only. ● Disconnected: USB port is not connected. status-page-lang Printer job language (PJL) that the print server uses to send the HP Jetdirect configuration/ status page to the printer. ● Auto (default): PJL is auto-detected when the print server is turned on or after a coldreset. ● PCL: HP Printer Control Language ● ASCII: Standard ASCII characters ENWW IPv4 configuration 55