HP 630n HP Jetdirect Print Servers - Administrator's Guide - Page 63
AppleTalk, DLC/LLC, Print Type - jetdirect 635n
UPC - 808736806244
View all HP 630n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Table 3-3 Telnet Commands and Parameters (continued) 2 (default): Enable. pjl-banner Print an IPX banner page through PJL. (ipx-banner) 0: Disable. 1 (default): Enable banner pages. pjl-eoj IPX end-of-job notification through PJL. (ipx-eoj) 0: Disable. 1 (default): Enable. pjl-toner-low IPX toner-low notification through PJL. (ipx-toner-low) 0: Disable. 1 (default): Enable. AppleTalk appletalk Use AppleTalk (EtherTalk) protocol operation on the print server. 0: Disable. 1 (default): Enable. NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are disabled by factory default. Name (Read-only parameter.) Name of the printer on the AppleTalk network. A number after the name indicates that this is the Nth instance of the name. Print Type (Read-only parameter.) AppleTalk network printer type reported by the HP Jetdirect print server. Up to three print types can be reported. Zone (Read-only parameter.) Name of the AppleTalk network zone on which the printer is located. Phase (Read-only parameter.) AppleTalk phase 2 (P2) is pre-configured on the HP Jetdirect print server. Status (Read-only parameter.) Current AppleTalk configuration status. READY: HP Jetdirect print server is awaiting data. DISABLED: AppleTalk was manually disabled. INITIALIZING: Print server is registering the node address or name. An additional status message might also be displayed. DLC/LLC dlc/llc-config Use DLC/LLC protocol operation on the print server (if supported). 0: Disable. 1 (default): Enable. NOTE: On HP Jetdirect 635n print servers, all network protocols except TCP/IP are disabled by factory default. strict-8022 Controls DLC/LLC protocol interpretation: 0 (default): Disable. Provide loose interpretation. ENWW IPv4 configuration 53