HP Designjet 250c Service Manual - Page 100
Reinstalling the Drive Roller, WARNING, CAUTION
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
10 Use the right cam journal to raise the Reinstalling the Drive Roller pinchĆwheels, and lift the right side of the drive roller up. WARNING In the following procedure, take care not to injure your fingers if you let the drive roller snap into place. CAUTION 11 Lift the roller out of the plotter. In the following procedure D Take care not to damage the media separator. Don't let it slip under the drive roller. D Take care that the edge of the media separator does not damage the rubber surface of the drive roller. 1 Flex the media separator upwards and position the roller behind it and on top of the pinch wheels. WARNING Reassembling: See following procedure. After reassembling, make sure that you check the carriageĆtoĆmedia distance ' page 7Ć11 2 Make sure that the gear on the left side of the roller is positioned immediately to the left of the sideĆplate. 6Ć42 Removal and Replacement C4699Ć90000