HP Designjet 250c Service Manual - Page 162
EEROM Model ID Configuration Procedure for the DesignJet 330, and 350C
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
330 350C EEROM Model ID Configuration Procedure for the DesignJet 330 and 350C The EEROM model ID configuration procedure only needs to be carried out if: D A preĆconfigured board is being reused. D The current board is incorrectly configured to the wrong model ID. D The plotter shows an unconfigured model ID system error (Steady 135). It is very rare that these situations will ever occur. Configure the plotter model ID as follows: 1 Remove the left cover ' page 6Ć10. 2 Disconnect the media motor encoder cable from the main PCA (connector ENC X). 3 Turn the plotter ON in Service Mode 1. 4 Hold the ALT key down and press the Deconfiguration Mode key. 5 Once in Deconfiguration Mode, the first and second LED columns should light up. ALT Deconfiguration Mode 6 Using a suitable tool, shortĆcircuit pins 1 and 2 (the first two pins on the right) of the media motor encoder connector (ENC X). The second and third LED columns should light up as you shortĆciruit the two pins. 7 Once you have shortĆcircuited the two pins, the first and second LED columns should light up again. Shift 8 Press the Shift key to exit the Deconfiguration Mode. 8Ć28 Troubleshooting C4699Ć90000