HP Designjet 250c Service Manual - Page 79
Removing the Right Bracket, Removing the Carriage Motor, from the clip at the back of the plotter.
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Removing the Right Bracket Removing the Carriage Motor 1 Remove the encoder strip ' page 6Ć17. 2 Remove the screw that attaches the right bracket to the plotter chassis. 1 Remove the right bracket ' page 6Ć21. 2 Disconnect the carriageĆmotor cable from the main PCA (connector MOT Y), and from the clip at the back of the plotter. Torx-20 Reassembling: Use the long screw. Threaded length ≅ 3 cm (∼1.2 inch). 3 Pull the right bracket to the right, and remove it from the plotter, CAUTION In the following step, take care not to break the black plastic tab on top of the motor. 3 Press the carriage motor towards the left, and remove the belt from the motor shaft. If you need greater maneuverability of the motor, press the black plastic tab on top very slightly downwards. B A Reassembling: Insert the rightĆbracket tab into the slot on the right of the trailingĆcable guide. C4699Ć90000 Removal and Replacement 6Ć21