HP Designjet 250c Service Manual - Page 145
Faulty carriage PCA., Turn the plotter off, and then on again to see if the problem disappears.
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Steady 356 Error + Fast + Load Media: Problems in movement in the XĆaxis (media axis) The possible causes could be: D Something is causing too much friction in the X-axis. D Paper jam. Steady 368 Error + Load Media + Normal: Error in XĆaxis calibration Did you load media in correct orientation? D Are the marks visible on the plot? If not, check cartridges. D Are cartridges correctly aligned? If so, the problem may be in the electronics module, media motor or driveĆroller gear; if alignment is incorrect, the problem may be in the carriage. There could also be a problem with the line sensor. Steady 1234 Paper + Cartridges + Error + Film: Communication broken between the two processors on the main PCA. Replace the electronics module. Steady 1238 Paper + Cartridges + Error + Normal: Electrical error The possible causes could be: D Missing or badly seated cartridge. D One end of the trailing cable is not connected or is badly connected, or the trailing cable is faulty. D Faulty fan, or fan is disconnected. D Faulty carriage PCA. D Faulty electronics module. For more precise troubleshooting ' page 8Ć19, w System Errors. Steady 1345 Paper + Error + Film + Fast: Not enough memory for the sensor data structure. D Turn the plotter off, and then on again to see if the problem disappears. D If the problem remains, consult recent service notes for a possible solution. D If no service note deals with this error, report the problem to your HP Response Center. Note conditions and actions before error occurred. Include setup sheet and service configuration plot in report. Steady 1346 Paper + Error + Film + Load Media: Problems in the free movement of the carriage. The possible causes could be: D Something is causing excessive friction in the YĆaxis (carriage axis). D The carriage touches the bail as it moves. See also error code Steady 346. C4699Ć90000 Troubleshooting 8Ć11