HP Designjet 250c Service Manual - Page 95

Removing the Cartridge Carriage 1 Remove the encoder strip ' page 6Ć17. 2 Remove the right bracket ' 6Ć21. CAUTION In the following step, take care not to break the black plastic tab on top of the motor. 4 Rotate the motor on its hinge out towards the back of the plotter. 3 Press the carriage motor towards the left, and remove the belt from the motor shaft. If you need greater maneuverability of the motor, press the black plastic tab on top very slightly downwards. 5 Release the belt from the pulley on the left of the plotter. B Reassembling: Make sure the belt is correctly positioned on the grooves of the pulley. A WARNING In the following steps, take care neither to cut yourself on the encoder strip, nor to damage the strip. Reassembling: Make sure the belt is correctly positioned on the grooves of the shaft. C4699Ć90000 Removal and Replacement 6Ć37