HP Designjet 250c Service Manual - Page 189
Once the the LEDs begin to light up one by one, release the, keys down, switch the plotter on.
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
330 350C Clearing the EEROM for the DesignJet 330 and 350C CAUTION If you clear the calibration parameters, you will then need to perform the plotter calibrations. (Details ' chapter 7.) Clearing the EEROM also resets the factory spittoon value to 0% used. Keep in mind that the value printed on the service configuration plot may greatly underestimate the amount of ink in the spittoon. Clearing Just the Benchrun and Calibration Parameters 1 Switch the plotter off. 2 While holding both the Replot and Media Type keys down, switch the plotter on. 3 Once the the LEDs begin to light up one by one, release the Replot and Media Type keys. Replot Media Type Clearing Just the UserĆDefined Setup Parameters 1 Switch the plotter off. 2 While holding both the Form Feed and Print Quality keys down, switch the plotter on. 3 Once the the LEDs begin to light up one by one, release the Form Feed and Print Quality keys. Clearing All Parameters 1 Switch the plotter off. 2 While holding both the Roll/Sheet and Continue Plotting keys down, switch the plotter on. 3 Once the the LEDs begin to light up one by one, release the Roll/Sheet and Continue Plotting keys. Form Feed Print Quality Continue Plotting Roll/Sheet C4699Ć90000 Troubleshooting 8Ć55