HP Designjet 250c Service Manual - Page 97
Removing the Drive Belt, Reassembling, under, Calibration
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
10 Slide the carriage to the right, and remove it with the belt from the plotter. Removing the Drive Belt 1 Remove the cartridge carriage ' page 6Ć37. 2 Release the belt from the clips on the underside of the carriage. Reassembling: Position the belt under the back extrusion of the carriage. Make sure that you correctly reconnect the trailing cable ' page 6Ć35. Reassembling: Clip the belt to the carriage, After reassembling, make sure that you check using the same part of the belt as was the carriageĆtoĆmedia distance ' page 7Ć11. originally used. Also, match the vertical lines on the belt with the vertical grooves on the carriage. The horizontal lines on the belt face Calibration: After having reassembled the outwards. plotter, perform the black cartridgeĆalignment. (Details ' User's Guide.) C4699Ć90000 Removal and Replacement 6Ć39