HP Designjet 250c Service Manual - Page 106
Removing the Entry Platen, Release the indicated entryĆplaten clips
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Removing the Entry Platen 1 Remove the overdrive enclosure ' page 6Ć46. 2 Disconnect the mediaĆsensor cable from the main PCA (connector labeled MEDIA). 4 Remove the indicated two screws from the left sideĆplate. Torx-15 Torx-20 2 3 5 Release the indicated entryĆplaten clips by pushing the bottom front corners of the entry platen up. 3 Remove the indicated screw from the right sideĆplate. Torx-15 6 Pull the entry platen horizontally out 1 from the plotter. 6Ć48 Removal and Replacement Reassembling: See the following procedure. C4699Ć90000
6Ć48
Removal and Replacement
C4699Ć90000
Removing the Entry Platen
1
Remove the overdrive enclosure
'
page
6Ć46.
2
Disconnect the mediaĆsensor cable from
the main PCA (connector labeled
MEDIA).
3
Remove the indicated screw from the
right sideĆplate.
Torx-15
1
4
Remove the indicated two screws from
the left sideĆplate.
Torx-15
2
Torx-20
3
5
Release the indicated entryĆplaten clips
by pushing the bottom front corners of
the entry platen up.
6
Pull the entry platen horizontally out
from the plotter.
Reassembling:
See the following procedure.