HP Designjet 250c Service Manual - Page 199
Firmware Revision Level
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
Firmware Revision Level The plotter firmware is contained either on a flash ROM SIMM at the back of the plotter or on a masked ROM inside the electronics module. The firmwareĆrevision level, for example A.01.03, is printed by the plotter on the setup sheet and on the service configuration plot. The revision level is also printed on a label on any flash ROM SIMM. Do not open the electronics module. Important: When replacing the electronics module, always remember to check the firmware revision level of the new electronics module. The revision level will be printed on the top surface of the module. Also, check the firmware revision level of the ROM SIMM installed in the old electronics module. With this information you must do the following: 1. If the firmware revision level of the ROM SIMM in the old electronics module is lower than the firmware revision level of the new electronics module, then you must not install the ROM SIMM into the module. 2. If the firmware revision level of the ROM SIMM in the old electronics module is higher than the firmware revision level of the new electronics module, then you must install the ROM SIMM into the module. Example 1: The ROM SIMM firmware revision level is A.01.03 and the firmware revision level of the electronics module is A.01.04. You would use the electronics module without the ROM SIMM installed. Example 2: The ROM SIMM firmware revision level is A.01.05 and the firmware revision level of the electronics module is A.01.04. You would use the electronics module with the ROM SIMM installed. C4699Ć90000 Product History and Service Notes 9Ć3