HP Designjet 250c Service Manual - Page 84
Removing the Media Motor, respectively, and from the clip
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Removing the Media Motor 1 Remove the spittoon ' page 6Ć23/6Ć24. 2 Disconnect the mediaĆmotor cable and the flat mediaĆaxisĆencoder cable from the main PCA (connectors labeled MOT X and ENC X respectively), and from the clip at the back of the plotter. 4 Pull the media motor out through the back of the plotter. Reassembling: The worm pinion and driveĆroller gear mesh slightly during use. Don't install a new motor and an old gear, or vice versa: install the gear that comes with the motor. Apply the grease that comes with the new motor to the worm pinion and driveĆroller gear. 3 Remove the two screws that secure the media motor to the mediaĆmotor mount. Calibration: After having reassembled the plotter, perform the accuracy calibration (Details ' chapter 7.) Torx-15 6Ć26 Removal and Replacement C4699Ć90000