HP Designjet 250c Service Manual - Page 121
To adjust the carriageĆtoĆmedia distance, DGO DNO GO
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
10 Move the carriage back into the service station. 11 Close the top cover. To adjust the carriageĆtoĆmedia distance You will need to adjust the carriageĆtoĆmedia distance if: D The ledge on the carriage did not pass over the GO side of the gauge. This means that the carriage is positioned too close to the drive roller. D The ledge on the carriage did pass over the NO GO side of the gauge. This means that the carriage is positioned too far from the drive roller. Adjust the carriageĆtoĆmedia distance as follows: 1 Release the two indicated clips on the top of the cartridge carriage by pulling them slightly outwards. WARNING Take care neither to cut yourself on the encoder strip, nor to damage the strip. 2 Pull the top of the carriage up. C4699Ć90000 Calibrations and Adjustments 7Ć13