HP Designjet 250c Service Manual - Page 153
System Errors for the DesignJet 230 and 250C Plotters, Line Number, Filename, Failure
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
230 250C System Errors for the DesignJet 230 and 250C Plotters The DesignJet 230 and 250C plotters have many failure modes that cause system errors. Many are due to electrical problems, others electronic, and some mechanical. To more precisely troubleshoot the system error, you may be able to find out what line of the firmware code the error appeared, and interpret this line; 1 If possible, print the service configuration plot (see ' page 8Ć49). The last system error, and the line number of the system error are printed on this plot. 2 See if the line number also appears in the following table. (Make sure that you also know which firmware revision the plotter is using, since a given line number corresponds to different lines in different revisions.) Filename testmode.c testmode.c testmode.c testmode.c testmode.c testmode.c Line Number Firmware Firmware Firmware A.01.03 A.01.04 A.01.05 Failure (and most frequent causes) - 1735 1739 YĆaxis servo error during bench run. - 1907 1973 X/YĆaxis servo error during bench run. 3014 3013 3079 Cartridge continuity: D Cartridges badly seated. D Faulty or badly connected trailing cable. D Dirty carriage flex circuit. D Faulty carriage. D Faulty electronics module. 2950 or 2959 2949 or 2958 3015 Secondary Fibis test failed: or 3024 D Faulty electronics module. 2974 2973 3039 Error in swathĆRAM test: D Faulty electronics module. 2992 2991 3057 Error in cartridgeĆvoltage regulation: D Faulty or badly connected trailing cable. D Faulty carriage. D Faulty electronics module. C4699Ć90000 Troubleshooting 8Ć19