HP Designjet 250c Service Manual - Page 99
Removing the Drive Roller, Remove the three screws that attach
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Removing the Drive Roller 8 Remove the mediaĆmotor mount. 1 Remove the driveĆroller gear ' page 6Ć25. 2 Remove the media motor ' page 6Ć26. 3 Remove the pinchĆarmĆlever linkage ' page 6Ć27. 4 Remove the engagingĆlever support ' page 6Ć31. 5 Remove the large black plastic gear from the left sideĆplate. Torx-20 9 Snap the overdrive clips to the right, and remove them from under the media separator. D/A1Ćsize plotters have two clips. E/A0Ćsize plotters have three clips. 6 Remove the overdrive roller ' page 6Ć32. 7 Remove the three screws that attach the mediaĆmotor mount to the right sideplate. C4699Ć90000 Torx-20 Removal and Replacement 6Ć41
6Ć41
Removal and Replacement
C4699Ć90000
Removing the Drive Roller
1
Remove the driveĆroller gear
'
page 6Ć25.
2
Remove the media motor
'
page 6Ć26.
3
Remove the pinchĆarmĆlever linkage
'
page 6Ć27.
4
Remove the engagingĆlever support
'
page 6Ć31.
5
Remove the large black plastic gear from
the left sideĆplate.
Torx-20
6
Remove the overdrive roller
'
page 6Ć32.
7
Remove the three screws that attach the
mediaĆmotor mount to the right sideplate.
Torx-20
8
Remove the mediaĆmotor mount.
9
Snap the overdrive clips to the right, and
remove them from under the media
separator.
D/A1Ćsize plotters have two clips.
E/A0Ćsize plotters have three clips.